DJI Mavic Pro Tablet Holder

A3DMPH

Don't be restricted to a small flight screen.  This holder allows you to attach an extendable tablet holder to use a larger screen device as your flight screen.  This will allow the use of an iPad Mini, iPad, iPad Pro (9.7" only recommended), Galaxy Tab etc.

This holder has been designed to allow multiple fixing positions for optimal placement of the tablet device depending on preference.  The design also means that whichever fixing position is chosen there are upper and lower end stops which prevent the screen being pushed/pulled too far back or too far forward removing any 'screen flop'.  Each fixing position allows a full 90 degrees of tilt (70º backward tilt and 20º forward tilt) ensuring you can find the optimum viewing angle.

The bracket itself is the same size as an iPhone 6 which ensures optimal hold in the DJI Mavic side arms. The vertical support provides ultimate hold and even has a 90º cross brace to ensure absolutely no movement whatsoever.  This bracket is tough!

The bracket is intended to be used with your existing Inspire 1 or Phantom3/4 mobile device holder.  These items can also be bought directly from the DJI Accessory Store if required.

Finished with the DJI and MAVICPRO logos it also looks the part, is available in black or white and made to the usual Aero3D exacting standards so you can be sure your tablet device, controller and flying pleasure will not be compromised.

Available in Black or White and a new, LIMITED TO 200 UNITS ONLY, Metallic Silver option, that is super cool.

FITTING INSTRUCTIONS

To create the complete mounting system you will need to obtain a new device holder (genuine DJI part 45 recommended) or re-use your existing DJI device holder.  

  • If re-using your existing then please unscrew the fixing bolt that attaches the holder to the controller mounting arm.
  • Place the device holder over the required fixing point.
  • Place the existing bolt thread through the device holder mounting hole and then slowly tighten the bolt using a suitable screw driver. The fixing hole is intentionally fractionally smaller than the fixing bolt to allow the built to 'bite' it's way through the plastic fixing hole too ensure a snug fit.
  • Please do not attempt to hammer or force the bolt through the fixing hole. It is intentional that the bolt create it's own thread through the plastic fixing hole.  This ensures there is no 'slop' in the fi=xing to add undue pressure on the fixing point.

This item is 3D printed from materials that exhibit exceptional strength (HTPLA, PLA+ & Polymax) and exhibit excellent print consistency and strength (stronger than ABS).  Together with the specific design features this item provides exceptional strength and overall quality.

Earn 0 reward points
£14.99 £17.99

Colour

QTY:
Out Of Stock
Add To Wishlist


We currently have 20 in stock.

Want to be notified when this product is back in stock? Complete the form below and we'll send you an email when it is.

The item has been added to your basket

Continue Shopping
Proceed To Checkout